Tail Trimmer Tailwell Standard

Tailwell has only three moving parts. Of these, only one - the self-lubricating sliding-block Rotator Bearing - is subject to any wear. The reduction in moving parts has resulted in a cutting machine that draws the minimum amount of power, ensuring the maximum number of tails are cut from each charge.

Tailwell should be used on a 14 volt cordless power drill, with an operating speed of 1,200 to 1,750rpm. (Higher or lower drill speeds do not cut better, and may damage the machine, voiding any warranty.) A lightweight drill with a high quality battery is the best to use. A quality Li-ion 1.5Amh 14v drill battery should allow trimming of about 70 tails per charge, depending on conditions. The Tailwell is simply placed through the flexible drill sleeve, and the chuck tightened firmly on the drive shaft. The drill sleeve is then pulled back firmly onto the drill body to prevent any rotation of the machine. The bungee cord is then put around the back of the drill and pulled firm. This part is for safety only, to prevent the Tailwell dropping off the drill if the chuck becomes loose.

If tails are not contaminated by sand, the cutters should stay sharp for more than 2,000 tails (depending on conditions). Sharpening the cutters is easily done by inexperienced users. The cutters are removed by opening the drive case. (Tools are supplied for this.) Honing paste is then applied to the cutter faces and they are 'ground' together by hand. This process should take only a few minutes. DVD and hard copy instructions are supplied.

Most important is regular and frequent lubrication of the cutters. Special oil is supplied in the kit. Tailwell Cutter Lubricant has been formulated specially for this purpose. It is a non-throw, non-dust-gathering light oil which will not 'clog' the cutters. We strongly recommend continued use of this lubricant, available from your Tailwell stockist. Lubricant should be used sparingly but frequently on the cutter tips - every 30-40 tails (or more frequently with sand contamination).

If cutting performance drops, the cutter tension should be adjusted promptly, before hair becomes trapped between them. This is achieved using the three finger-only screws at the back of the cutter head. Follow instructions supplied. Cutters must be kept correctly tensioned at all times to ensure correct cutting performance and cutter life. We strongly recommend viewing in full the instructional DVD supplied, before first use of your machine.

Tail Trimmer Tailwell Standard Highlights:

• SKU: 11381
• Manufacturer: Shoof International
• For smooth, fast trimming of tail in one pass
• Good cutter life in situations of sand contaminated tails
• A super-hard coating prevents the early wear and tear that the sand causes, therefore extending the life of the cutters
• Trim tails within seconds during milking or in the barn
• Cutters will last up to 3,000 sand-embedded tails (or about 6,000 non-seriously contaminated tails)
• A reduced cutting power demand extends the life of the drill battery and results in reduced user fatigue
• New model is light and easy to handle, reduced size and weight to only
• A quality Li-ion 1.5Amh drill battery should allow trimming of about 70 tails per charge, depending on conditions
• If tails are not contaminated by sand, the cutters should stay sharp for 1000 to 2000 tails